Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID
RM3700E _51 Engine / Hybrid System _093768 M15A-FXE ENGINE CONTROL _0442033 CAMSHAFT OIL CONTROL SOLENOID G

M15A-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  INSPECTION  


PROCEDURE

Hide 15370 1.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

a.

Check the resistance.

i.
A436353C11
1.49,0.083 1.927,0.333 0.438,0.25 0.125,0.094 0.323,0.26 0.198,0.167 10 false *a 1.583,0.135 2.042,0.333 0.458,0.198 10 false D17
*a Component without harness connected
(Cam Timing Oil Control Solenoid Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(D17)Location & Routing

Click Connector(D17)Engine Compartment>Engine Wire>Cam Timing Oil Control Solenoid Assembly (Exhaust Side)

D17-1 - D17-2 0 °C (32 °F) 6.3 to 7.3 Ω
D17-1 - D17-2 20 °C (68 °F) 6.9 to 7.9 Ω
D17-1 - D17-2 40 °C (104 °F) 7.4 to 8.6 Ω


If the result is not as specified, replace the cam timing oil control solenoid assembly.



b.

Stroke Amount Inspection

i.
A436356C01
1.198,1.344 1.583,1.344 false 1.188,2.229 1.573,2.229 false 0.125,0.333 0.438,0.49 0.313,0.156 10 false *a 0.146,2.542 0.458,2.698 0.313,0.156 10 false *b 1.021,1.281 1.333,1.438 0.313,0.156 10 false *c 1.01,2.156 1.323,2.313 0.313,0.156 10 false *c 2.25,1.208 2.563,1.365 0.313,0.156 10 false A 2.24,2.26 2.552,2.417 0.313,0.156 10 false B
*a Shaft Side Facing Down
*b Shaft Side Facing Up
*c Shaft


Using vernier calipers, measure length (A) and (B) with the shaft of the cam timing oil control solenoid assembly set in the respective positions shown in the illustration.

NOTICE:

Do not apply auxiliary battery voltage to the terminals of the cam timing oil control solenoid assembly.


HINT:

If the shaft does not extend under its own weight, extend the shaft with your fingers.



ii.

Calculate the stroke amount based on the difference of length (A) and (B).

Standard:
Specified Condition
4.3 mm or higher
0.169 in. or higher


HINT:

Stroke amount = length (A) - length (B)


If the value is not as specified, replace the cam timing oil control solenoid assembly.