Home › Engine / Hybrid System › M15A-FKS (COOLING) › RADIATOR
RM3700E _51 Engine / Hybrid System _093771 M15A-FKS COOLING _0442077 RADIATOR G

M15A-FKS COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT RADIATOR CAP SUB-ASSEMBLY

a.
A284342C02
0.302,1.438 0.615,1.594 0.313,0.156 10 false *a 0.594,1.677 0.906,1.833 0.313,0.156 10 false *b 0.833,1.906 1.146,2.063 0.313,0.156 10 false *c 2.625,1.708 2.938,1.865 0.313,0.156 10 false *d
*a Rubber packing (1)
*b Rubber packing (2)
*c Rubber packing (3)
*d Valve seat


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on the rubber packings (1), (2) or (3), clean the part(s) with water and finger scouring.


ii.

Check that the rubber packings (1), (2) and (3) are not deformed, cracked or swollen.


iii.

Check that the rubber packing (3) and valve seat are not stuck together.


iv.

Apply engine coolant to the rubber packings (2) and (3) before using the radiator cap tester.


v.
A284343C03
1.469,0.771 1.885,0.354 false 0.365,1.156 0.469,1 false 0.167,1.115 0.479,1.313 0.313,0.198 10 false *1 1.958,0.292 2.271,0.49 0.313,0.198 10 false *a 1.344,1.156 1.573,1.313 0.229,0.156 10 true *b
*1 Radiator Cap Sub-assembly
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it upwards 30° or more.


vi.

Pump the radiator cap tester several times, and check the maximum pressure.

Pump Speed:

1 pump per second


HINT:

Even if the radiator cap sub-assembly cannot maintain the maximum pressure, it is not a defect.


Result:
Item Specified Condition
Standard pressure
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13 to 18 psi)
Minimum pressure
(for used cap)
79 kPa (0.8 kgf/cm2, 11 psi)


If the maximum pressure is less than the minimum pressure, replace the radiator cap sub-assembly.