Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
1.INSPECT FOR COOLANT LEAK (for Engine)
Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap sub-assembly.
| *a | Radiator Cap Tester |
Fill the radiator reserve tank assembly with engine coolant, and then install a radiator cap tester.
Set the engine in inspection mode.
Warm up the engine.
Pump the radiator cap tester to 123 kPa (1.3 kgf/cm2, 18 psi), and then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks.
If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.
Remove the radiator cap tester.
Install the radiator cap sub-assembly.
2.INSPECT RADIATOR RESERVE TANK ENGINE COOLANT LEVEL (for Engine)
| *a | F Line |
| *b | L Line |
Check that the engine coolant level is between the L line and F line when the engine is cold.
Do not substitute plain water for engine coolant.
If the engine coolant level is low, check for leaks and add engine coolant to the F line.
3.INSPECT ENGINE COOLANT QUALITY (for Engine)
Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap sub-assembly.
Check that there are no excessive deposits of rust or scale around the radiator cap sub-assembly and engine coolant hole. Also, the engine coolant should be free of oil.
If excessively dirty, clean the engine coolant passage and replace the engine coolant.
Install the radiator cap sub-assembly.