Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP › 2020.08–2021.07
RM3700E _54 Brake _093767 BRAKE SYSTEM (OTHER) _0442068 VACUUM PUMP G

BRAKE SYSTEM (OTHER)  VACUUM PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.
C435064C01
2.542,3.625 2.177,3.771 2.177,3.771 2.542,3.365 true 2.042,3.75 2.354,3.906 0.313,0.156 10 false *a
*a Retainer
V100135

Pinch
V113148

Pull off


Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.

NOTICE:

Be sure to disconnect the No. 1 vacuum hose connector by hand.



b.
C429855C01
0.281,1.292 0.281,0.875 true 1.167,0.177 1.5,0.177 true 1.573,0.104 1.75,0.281 0.177,0.177 10 true *a 0.188,1.333 0.385,1.5 0.198,0.167 10 true *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the vacuum of the vacuum pump assembly.

Standard Pressure:

More than 86.7 kPa (650 mmHg, 25.6 in.Hg)


HINT:
·

If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP>DISASSEMBLY

·

Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.




e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.