Home › Engine / Hybrid System › M15A-FXE (LUBRICATION) › OIL PRESSURE AND TEMPERATURE SENSOR
RM3700E _51 Engine / Hybrid System _093775 M15A-FXE LUBRICATION _0442099 OIL PRESSURE AND TEMPERATURE SENSOR G

M15A-FXE LUBRICATION  OIL PRESSURE AND TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89448D 1.INSPECT OIL PRESSURE AND TEMPERATURE SENSOR

a.

Check the oil pressure and temperature sensor output voltage.

i.
A426920C08
1.521,0.031 1.875,0.198 0.354,0.167 0.958,0.406 1.563,0.74 true 2.448,0.406 1.802,0.74 true 0.052,0.052 0.281,0.271 0.229,0.219 10 false *a 1.813,1.781 2,1.969 0.188,0.188 10 false *b 0.719,0.323 1.031,0.521 0.313,0.198 10 false VC 2.51,0.323 2.823,0.521 0.313,0.198 10 false GND 1.563,0.042 1.875,0.24 0.313,0.198 10 false D32
*a Component without harness connected
(Oil Pressure and Temperature Sensor)
*b Voltage Applied between Terminals


Apply 5 V between terminals 3 (VC) and 2 (GND).

NOTICE:
·

Be careful when connecting the leads as the oil pressure and temperature sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 3 (VC) or 2 (GND).



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.




b.
A426921C02
1.417,0.167 1.917,0.417 0.5,0.25 0.865,1.823 1.104,1.823 1.104,1.823 1.448,1.156 true 2.344,1.813 2.094,1.813 2.094,1.813 1.771,1.156 true 0.083,0.073 0.323,0.292 0.24,0.219 10 false *a 0.49,1.74 0.896,1.938 0.406,0.198 10 false TOUT 2.406,1.75 2.76,1.958 0.354,0.208 10 false GND 1.542,0.229 2,0.427 0.458,0.198 10 false D32
*a Component without harness connected
(Oil Pressure and Temperature Sensor)


Measure the voltage between terminals.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(D32)Location & Routing

Click Connector(D32)Engine Compartment>Engine Wire>Oil Pressure & Temperature Sensor

D32-4 (TOUT) - D32-2 (GND) 20°C (68°F) Approximately 1.5 to 2.5 V*


*: The output voltage changes depending on the voltage applied to the terminals.

If the result is not as specified, replace the oil pressure and temperature sensor.