CHECK POWER STEERING ECU ASSEMBLY
| *a | Component without harness connected
(Power Steering ECU Assembly) |
- | - |
Measure the voltage and resistance according to the value(s) in the table below.
When the EPS warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU assembly terminals to become 0 V.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H1-1 (IG) - Body ground | IG power source | Ignition switch ON | 8 to 16 V |
| H1-7 (CANH) - H1-8 (CANL) | CAN communication line | Ignition switch off | 54 to 69 Ω |
| H2-1 (PIG) - Body ground | Power source | Ignition switch ON | 8 to 16 V |
| H2-2 (PGND) - Body ground | Power ground | Always | Below 1 Ω |
If the result is not as specified, the ECU may be malfunctioning.