Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3700E _56 Audio / Visual / Telematics _093686 AUDIO / VIDEO _0442502 NOISE FILTER G

AUDIO / VIDEO  NOISE FILTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86011A 1.INSPECT RADIO SETTING CONDENSER

a.

With the radio setting condenser installed, check that there is no looseness or other abnormalities.


b.

Check the resistance.

i.
E386541C18
1.01,0.479 1.594,0.479 false 0.906,0.427 1.063,0.625 0.156,0.198 10 false 1 0.146,0.146 0.458,0.344 0.313,0.198 10 false *a
*a Radio Setting Condenser


Measure the resistance of the radio setting condenser according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body ground
·

Ignition switch off

·

Window defogger off


Below 1 Ω



ii.

If the result is not as specified, replace the radio setting condenser.



c.

Remove the bolt.


d.

Disengage the clamp to separate the radio setting condenser with wire harness from the vehicle body.


e.

Check the resistance.

i.
E230106C47
2.083,1.583 2.542,1.427 true 1.344,1.594 0.813,1.427 true 2.583,1.333 2.698,1.49 0.115,0.156 10 false 3 0.708,1.313 0.823,1.469 0.115,0.156 10 false 2 0.063,0.073 0.271,0.229 0.208,0.156 10 false *a
*a Radio Setting Condenser


Measure the resistance of the radio setting condenser according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3
·

Ignition switch off

·

Window defogger off


10 kΩ or higher



ii.

If the result is not as specified, replace the radio setting condenser.



f.

Check the voltage.

i.
E230106C45
1.344,1.594 0.813,1.427 false 0.708,1.313 0.823,1.469 0.115,0.156 10 false 2 0.063,0.073 0.271,0.229 0.208,0.156 10 false *a
*a Radio Setting Condenser


Measure the voltage of the radio setting condenser according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 - Body ground
·

Ignition switch on (IG)

·

Window defogger off


Below 1 V
2 - Body ground
·

Ignition switch on (IG)

·

Window defogger on


11 to 14 V



ii.

If the result is not as specified, replace the radio setting condenser.



g.

Engage the clamp to install the radio setting condenser with wire harness to the vehicle body.


h.

Install the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)