Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER › 2020.08–2021.07
RM3700E _56 Audio / Visual / Telematics _093686 AUDIO / VIDEO _0442490 REAR DOOR SPEAKER G

AUDIO / VIDEO  REAR DOOR SPEAKER  INSPECTION  


PROCEDURE

Hide 86160B 1.INSPECT REAR SPEAKER ASSEMBLY (for RH Side)

a.

Check the visually.

i.

With the speaker installed, check that there is no looseness or other abnormalities.


ii.

Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.


iii.

If the result is not as specified, replace the rear speaker assembly.



b.

Check the resistance.

i.
E364209C31
1.552,0.438 1.958,0.677 0.406,0.24 1.25,1.604 1.563,1.313 true 1.99,1.615 1.875,1.292 true 0.073,0.063 0.344,0.292 0.271,0.229 12 false *a 1.177,1.615 1.344,1.76 0.167,0.146 10 false + 2.031,1.594 2.198,1.74 0.167,0.146 10 false - 1.688,0.479 2,0.677 0.313,0.198 10 false M2
*a Component without harness connected
(Rear Speaker Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(M2)Location & Routing

Click Connector(M2)Body>No. 1 Rear Door Wire>Rear Speaker Assembly RH

M2-2(+) - M2-1(-) Always 4.0 Ω



ii.

If the result is not as specified, replace the rear speaker assembly.



Hide 86160B 2.INSPECT REAR SPEAKER ASSEMBLY (for LH Side)

a.

Check the visually.

i.

With the speaker installed, check that there is no looseness or other abnormalities.


ii.

Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.


iii.

If the result is not as specified, replace the rear speaker assembly.



b.

Check the resistance.

i.
E364209C32
1.552,0.438 1.958,0.677 0.406,0.24 1.25,1.604 1.563,1.313 true 1.99,1.615 1.875,1.292 true 0.073,0.063 0.344,0.292 0.271,0.229 12 false *a 1.177,1.615 1.344,1.76 0.167,0.146 10 false + 2.031,1.594 2.198,1.74 0.167,0.146 10 false - 1.688,0.479 2,0.677 0.313,0.198 10 false N2
*a Component without harness connected
(Rear Speaker Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(N2)Location & Routing

Click Connector(N2)Body>No. 2 Rear Door Wire>Rear Speaker Assembly LH

N2-2(+) - N2-1(-) Always 4.0 Ω



ii.

If the result is not as specified, replace the rear speaker assembly.