84840G
1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Entry and Start System)
Check the operation of the back door opener switch.
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y8)Location & Routingewd_type=routing;type=c;code=Y8 Click Connector(Y8)Body>No. 2 Back Door Wire>Back Door Opener Switch Assemblyewd_type=component;type=c;code=Y8;pinno=3,2 |
||
| Y8-3(UL) - Y8-2(E) | Back door opener switch not pushed (OFF) | 10 kΩ or higher |
| Y8-3(UL) - Y8-2(E) | Back door opener switch pushed (ON) | Below 1 Ω |
If the result is not as specified, replace the back door opener switch assembly.
Check the operation of the back door lock switch.
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y8)Location & Routingewd_type=routing;type=c;code=Y8 Click Connector(Y8)Body>No. 2 Back Door Wire>Back Door Opener Switch Assemblyewd_type=component;type=c;code=Y8;pinno=1,2 |
||
| Y8-1(L) - Y8-2(E) | Back door lock switch not pushed (OFF) | 10 kΩ or higher |
| Y8-1(L) - Y8-2(E) | Back door lock switch pushed (ON) | Below 1 Ω |
If the result is not as specified, replace the back door opener switch assembly.
84840G
2.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Entry and Start System)
Check the operation of the back door opener switch.
| *a | Component without harness connected
(Back Door Opener Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y8)Location & Routingewd_type=routing;type=c;code=Y8 Click Connector(Y8)Body>No. 2 Back Door Wire>Back Door Opener Switch Assemblyewd_type=component;type=c;code=Y8;pinno=3,2 |
||
| Y8-3(UL) - Y8-2(E) | Back door opener switch not pushed (OFF) | 10 kΩ or higher |
| Y8-3(UL) - Y8-2(E) | Back door opener switch pushed (ON) | Below 1 Ω |
If the result is not as specified, replace the back door opener switch assembly.