Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH
RM3700E _59 Vehicle Exterior _093706 DOOR / HATCH _0444896 POWER BACK DOOR CONTROL SWITCH G

DOOR / HATCH  POWER BACK DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84966A 1.INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH

a.

Check the resistance.

i.
B527656C07
1.531,1.531 1.979,1.75 0.448,0.219 0.698,3.063 1.229,2.594 true 1.281,3.052 1.448,2.583 true 2.146,3.052 1.979,2.594 true 2.719,3.052 2.198,2.573 true 0.146,0.104 0.583,0.427 0.438,0.323 10 false *a 1.125,3.094 1.583,3.292 0.458,0.198 10 false CLS 2.146,3.104 2.604,3.302 0.458,0.198 10 false E 0.531,3.094 0.99,3.292 0.458,0.198 10 false ILL+ 2.667,3.115 3.125,3.313 0.458,0.198 10 false ILL- 1.625,1.563 2.083,1.76 0.458,0.198 10 false Y21
*a Component without harness connected
(Back Door Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(Y21)Location & Routing

Click Connector(Y21)Body>No. 2 Back Door Wire>No. 1 Power Back Door Control Switch

Y21-5 (CLS) - Y21-2 (E) Switch off 10 kΩ or higher
Y21-5 (CLS) - Y21-2 (E) Switch on Below 1 Ω


If the result is not as specified, replace the back door control switch.



b.

Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the power back door main switch connector, and check that the back door control switch LED illuminates.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Terminal Y21-6 (ILL+)
Auxiliary battery negative (-) → Terminal Y21-1 (ILL-)
LED illuminates


If the result is not as specified, replace the back door control switch.