Home › Vehicle Exterior › DOOR / HATCH › RESERVE LOCK SWITCH
RM3700E _59 Vehicle Exterior _093706 DOOR / HATCH _0444897 RESERVE LOCK SWITCH G

DOOR / HATCH  RESERVE LOCK SWITCH  INSPECTION  


PROCEDURE

Hide 84931C 1.INSPECT BACK DOOR CONTROL SWITCH

a.

Check the resistance.

i.
B577977C08
1.469,1.677 1.875,1.906 0.406,0.229 0.885,3.094 1.198,2.698 true 1.406,3.115 1.406,2.688 true 2.01,3.115 2.01,2.698 true 2.51,3.135 2.229,2.698 true 0.552,1.688 0.865,1.844 0.313,0.156 10 false *a 1.271,3.125 1.885,3.323 0.615,0.198 10 false CLLS 0.771,3.115 1.385,3.313 0.615,0.198 10 false ILL+ 2.448,3.156 3.063,3.354 0.615,0.198 10 false ILL- 1.99,3.125 2.188,3.302 0.198,0.177 10 false E 1.531,1.698 1.99,1.896 0.458,0.198 10 false Y22
*a Component without harness connected
(Door Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(Y22)Location & Routing

Click Connector(Y22)Body>No. 2 Back Door Wire>Back Door Control Switch

Y22-5 (CLLS) - Y22-2 (E) Switch off 10 kΩ or higher
Y22-5 (CLLS) - Y22-2 (E) Switch on Below 1 Ω


If the result is not as specified, replace the back door control switch.



b.

Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the power back door main switch connector, and check that the back door control switch LED illuminates.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → Y22-6 (ILL+)
Auxiliary battery negative (-) → Y22-1 (ILL-)
LED illuminates


If the result is not as specified, replace the back door control switch.