84270G
1.INSPECT POWER BACK DOOR SENSOR ASSEMBLY RH
| *a | Component without harness connected
(Power Back Door Sensor RH) |
*b | Not Pressed |
| *c | Pressed | - | - |
Check the resistance of the power back door sensor RH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y25)Location & Routingewd_type=routing;type=c;code=Y25 Click Connector(Y25)Body>No. 2 Back Door Wire>Power Back Door Sensor Assembly RHewd_type=component;type=c;code=Y25;pinno=1,2 |
||
| Y25-1(OSR) - Y25-2(OSRE) | Not pressed | 950 Ω to 1050 Ω |
| Y25-1(OSR) - Y25-2(OSRE) | Pressed | Below 100 Ω |
If the result is not as specified, replace the power back door sensor RH.
84280D
2.INSPECT POWER BACK DOOR SENSOR ASSEMBLY LH
| *a | Component without harness connected
(Power Back Door Sensor RH) |
*b | Not Pressed |
| *c | Pressed | - | - |
Check the resistance of the power back door sensor LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(Y26)Location & Routingewd_type=routing;type=c;code=Y26 Click Connector(Y26)Body>No. 2 Back Door Wire>Power Back Door Sensor Assembly LHewd_type=component;type=c;code=Y26;pinno=1,2 |
||
| Y26-1(OSL) - Y26-2(OSLE) | Not pressed | 950 Ω to 1050 Ω |
| Y26-1(OSL) - Y26-2(OSLE) | Pressed | Below 100 Ω |
If the result is not as specified, replace the power back door sensor LH.