69050A
1.INSPECT REAR DOOR LOCK ASSEMBLY RH (w/o Smart Entry and Start System)
| *a | Component without harness connected
(Rear Door Lock Assembly RH) |
| *b | Lock |
| *c | Unlock |
Check the door lock motor operation.
Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(M1)Location & Routingewd_type=routing;type=c;code=M1 Click Connector(M1)Body>No. 1 Rear Door Wire>Rear Door Lock with Motor Assembly RHewd_type=component;type=c;code=M1;pinno=4,1 |
|
| M1-4(L) - Auxiliary battery positive (+)
M1-1(UL) - Auxiliary battery negative (-) |
Lock |
| M1-1(UL) - Auxiliary battery positive (+)
M1-4(L) - Auxiliary battery negative (-) |
Unlock |
If the result is not as specified, replace the rear door lock assembly RH.
69050A
2.INSPECT REAR DOOR LOCK ASSEMBLY RH (w/ Smart Entry and Start System)
| *a | Component without harness connected
(Rear Door Lock Assembly RH) |
| *b | Lock |
| *c | Unlock |
Check the door lock motor operation.
Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(M1)Location & Routingewd_type=routing;type=c;code=M1 Click Connector(M1)Body>No. 1 Rear Door Wire>Rear Door Lock with Motor Assembly RHewd_type=component;type=c;code=M1;pinno=4,1 |
|
| M1-4(L) - Auxiliary battery positive (+)
M1-1(UL) - Auxiliary battery negative (-) |
Lock |
| M1-1(UL) - Auxiliary battery positive (+)
M1-4(L) - Auxiliary battery negative (-) |
Unlock |
If the result is not as specified, replace the rear door lock assembly RH.
Check the operation of the unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(M1)Location & Routingewd_type=routing;type=c;code=M1 Click Connector(M1)Body>No. 1 Rear Door Wire>Rear Door Lock with Motor Assembly RHewd_type=component;type=c;code=M1;pinno=6,9 |
||
| M1-6(LSSR) - M1-9(E) | Lock | 10 kΩ or higher |
| M1-6(LSSR) - M1-9(E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the rear door lock assembly RH.
69060A
3.INSPECT REAR DOOR LOCK ASSEMBLY LH (w/o Smart Entry and Start System)
| *a | Component without harness connected
(Rear Door Lock Assembly LH) |
| *b | Lock |
| *c | Unlock |
Check the door lock motor operation.
Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(N1)Location & Routingewd_type=routing;type=c;code=N1 Click Connector(N1)Body>No. 2 Rear Door Wire>Rear Door Lock with Motor Assembly LHewd_type=component;type=c;code=N1;pinno=4,1 |
|
| N1-4(L) - Auxiliary battery positive (+)
N1-1(UL) - Auxiliary battery negative (-) |
Lock |
| N1-1(UL) - Auxiliary battery positive (+)
N1-4(L) - Auxiliary battery negative (-) |
Unlock |
If the result is not as specified, replace the rear door lock assembly LH.
69060A
4.INSPECT REAR DOOR LOCK ASSEMBLY LH (w/ Smart Entry and Start System)
| *a | Component without harness connected
(Rear Door Lock Assembly LH) |
| *b | Lock |
| *c | Unlock |
Check the door lock motor operation.
Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor.
| Tester Connection | Specified Condition |
|---|---|
|
Click Location & Routing(N1)Location & Routingewd_type=routing;type=c;code=N1 Click Connector(N1)Body>No. 2 Rear Door Wire>Rear Door Lock with Motor Assembly LHewd_type=component;type=c;code=N1;pinno=4,1 |
|
| N1-4(L) - Auxiliary battery positive (+)
N1-1(UL) - Auxiliary battery negative (-) |
Lock |
| N1-1(UL) - Auxiliary battery positive (+)
N1-4(L) - Auxiliary battery negative (-) |
Unlock |
If the result is not as specified, replace the rear door lock assembly LH.
Check the operation of the unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(N1)Location & Routingewd_type=routing;type=c;code=N1 Click Connector(N1)Body>No. 2 Rear Door Wire>Rear Door Lock with Motor Assembly LHewd_type=component;type=c;code=N1;pinno=6,9 |
||
| N1-6(LSSR) - N1-9(E) | Lock | 10 kΩ or higher |
| N1-6(LSSR) - N1-9(E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the rear door lock assembly LH.