DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's skid control ECU (brake actuator assembly).
The skid control ECU (brake actuator assembly) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.
To check the DTCs, connect the GTS to the DLC3 on the vehicle. The GTS enables you to clear the DTCs, activate the various actuators, and check the Freeze Frame Data and Data List.
Check the auxiliary battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge the auxiliary battery before proceeding to the next step.
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
DIAGNOSIS
If a malfunction occurs in one part of the system, the skid control ECU (brake actuator assembly) illuminates the warning light corresponding to the malfunctioning system (ABS warning light, brake system warning light or slip indicator light).
The DTCs are simultaneously stored in memory. The DTCs can be read by connecting the GTS.
This system has a Dealer Mode (Signal Check) function.
WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
When the ignition switch is turned to ON, check that the ABS warning light, brake warning light, VSC OFF indicator light, slip indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.
When the brake fluid level is low, the brake system warning light comes on.
If a light does not illuminate, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).
If the ABS warning light or slip indicator light remains illuminated after approximately 3 seconds check for DTCs and check the corresponding code. If no DTC is output, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).