If air bleeding has not been performed, the skid control ECU (brake booster with master cylinder assembly) stores DTC C145151 to prevent the entry of air due to pump motor operation.
DTC C145151 is stored when Motor Invalid is selected, the system will not return to normal until the air bleeding procedure is performed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C145151 | High Pressure Tube Air Bleeding Not Programmed | Any of the following is detected:
·
Using the GTS, "Motor Invalid" of the "ECB Utility" has been performed. ·
The brake booster with master cylinder assembly has been replaced. |
Air bleeding not performed | Brake/EPB | A |
Bleed the air from the brake system.
If air bleeding has been performed, this DTC will be cleared.
| Proceed to |
|---|
| NEXT |
NEXT
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| C145151 is output | A |
| C145151 is not output | B |
A
B