Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH
RM3700E _58 Vehicle Interior _093747 DOOR LOCK _0448389 UNLOCK WARNING SWITCH G

DOOR LOCK  UNLOCK WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84052 1.INSPECT UNLOCK WARNING SWITCH ASSEMBLY

a.

Check the resistance.

i.
B565989C01
1.521,0.5 1.854,0.719 0.333,0.219 1.198,3.792 1.604,4.135 false 1.313,1.865 1.594,1.438 true 2.146,1.854 1.823,1.448 true 1.635,4.146 1.969,4.281 0.333,0.135 10 false *b 0.552,0.375 0.75,0.531 0.198,0.156 10 false *a 2.125,1.906 2.583,2.104 0.458,0.198 10 false UN+ 1.167,1.896 1.625,2.094 0.458,0.198 10 false UN- 1.563,0.531 2.021,0.729 0.458,0.198 10 false H55
*a Component without harness connected
(Unlock Warning Switch Assembly)
*b Switch


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(H55)Location & Routing

Click Connector(H55)Instrument Panel>Instrument Panel Wire / Speaker Wire>Un-Lock Warning Switch Assembly

H55-1(UN+) - H55-2(UN-) Pushed Below 1 Ω
H55-1(UN+) - H55-2(UN-) Not Pushed 10 kΩ or higher


If the result is not as specified, replace the unlock warning switch assembly.