84153
1.INSPECT AUTO HIGH BEAM SWITCH
| *a | Component without harness connected
(Auto High Beam Switch) |
Resistance Check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H47)Location & Routingewd_type=routing;type=c;code=H47 Click Connector(H47)Instrument Panel>Instrument Panel Wire / Speaker Wire>Auto High Beam Switchewd_type=component;type=c;code=H47;pinno=5,2 |
||
| H47-5 (+B) - H47-2 (E) | Auto high beam switch off | 10 kΩ or higher |
| H47-5 (+B) - H47-2 (E) | Auto high beam switch on | Below 1 Ω |
If the result is not as specified, replace the auto high beam switch.
Illumination Inspection
Apply auxiliary battery voltage to the auto high beam switch and check that the switch illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| H47-6 (ILL+) - Auxiliary battery positive (+)
H47-1 (ILL-) - Auxiliary battery negative (-) |
Switch illumination illuminates |
| Measurement Condition | Specified Condition |
|---|---|
| H47-3 (IND+) - Auxiliary battery positive (+)
H47-4 (AZBI) - Auxiliary battery negative (-) |
Switch indicator illuminates |
If the result is not as specified, replace the auto high beam switch.