84988H
1.INSPECT DOWNHILL ASSIST CONTROL SWITCH
| *a | Component without harness connected
(Downhill Assist Control Switch) |
Check the resistance.
If the result is not as specified, replace the downhill assist control switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H133)Location & Routingewd_type=routing;type=c;code=H133 Click Connector(H133)Instrument Panel>Instrument Panel Wire / Speaker Wire>Downhill Assist Control Switchewd_type=component;type=c;code=H133;pinno=2,5 |
||
| H133-2 (E) - H133-5 (B) | Switch pushed | Below 1 Ω |
| H133-2 (E) - H133-5 (B) | Switch not pushed | 10 kΩ or higher |
| *a | Component without harness connected
(Downhill Assist Control Switch) |
Check the illumination.
Apply auxiliary battery voltage to the downhill assist control switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H133)Location & Routingewd_type=routing;type=c;code=H133 Click Connector(H133)Instrument Panel>Instrument Panel Wire / Speaker Wire>Downhill Assist Control Switchewd_type=component;type=c;code=H133;pinno=6,1 |
||
| H133-6 (ILL+) - H133-1 (ILL-) | H133-6 (ILL+) - Auxiliary battery positive (+)
H133-1 (ILL-) - Auxiliary battery negative (-) |
The downhill assist control switch illumination illuminates. |
If the result is not as specified, replace the downhill assist control switch.