Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY › from 2021.07
RM3700E _55 Steering _093030 STEERING COLUMN _0438540 STEERING COLUMN ASSEMBLY G

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure as for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C456369C01
0.927,1.51 1.25,1.51 true 0.917,1.333 0.917,1.75 0.917,1.75 1.25,1.75 false 2.302,1.24 2.844,1.24 true 0.75,1.333 1.25,1.333 true 0.563,1.219 0.76,1.406 0.198,0.188 10 false *a 2.917,1.156 3.229,1.313 0.313,0.156 10 false *b
*a Wooden Block
*b Cloth


Secure the steering column assembly in a vise using aluminum plates, cloths and wooden blocks.

NOTICE:
·

Do not overtighten the vise, as the steering column assembly may become deformed.

·

Support the steering column assembly with wooden blocks or similar items to ensure that it does not fall.




b.
C441764

Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt to the steering main shaft.

NOTICE:

Do not apply excessive torque to the steering wheel assembly set bolt by using a tool such as an impact wrench.


HINT:

The steering wheel assembly set bolt is used for turning the steering main shaft during inspection of the steering main shaft rotating torque.



c.
C456370C01
0,0 0,0 false
V113147

Turn


Using a torque wrench, turn the steering main shaft at a constant rate of approximately 1 revolution every 4 seconds and measure the preload.

Preload:

0.9 to 3.0 N*m (10 to 30 kgf*cm, 8 to 26 in.*lbf)



d.

If the preload is not as specified, replace the power steering ECU assembly or electric power steering column sub-assembly with a new one.


e.

Remove the steering wheel assembly set bolt.


Hide 2.INSPECT STEERING COLUMN ASSEMBLY

a.
C456371

Check that the 2 bushings are securely installed to the steering column assembly.


b.

If the bushings are deformed, missing or damaged, replace the electric power steering column sub-assembly with a new one.