84250A
1.INSPECT STEERING PAD SWITCH ASSEMBLY
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *A | w/ Dynamic Radar Cruise Control System | *B | w/ ASL Switch |
| *C | w/o ASL Switch | - | - |
| *a | Component without harness connected
(Steering Pad Switch Assembly) |
*b | Up |
| *c | Down | *d | Right |
| *e | Left | *f | OK |
| *g | Back | *h | On/off Hook |
| *i | Voice | *j | Volume+ |
| *k | Volume- | *l | Seek+ |
| *m | Seek- | *n | MODE |
| *o | +RES | *p | -SET |
| *q | CANCEL | *r | Lane Tracing Assist |
| *s | Distance Control | *t | Cruise Control Main |
| *u | ASL | - | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: w/ Dynamic Radar Cruise Control System *2: w/ ASL Switch |
||
|
Click Location & Routing(z2)Location & Routingewd_type=routing;type=c;code=z2 Click Connector(z2)Instrument Panel>other>Steering Pad Switch Assembly , Spiral Cable Sub-Assemblyewd_type=component;type=c;code=z2;pinno=3,10,9,5,4,8,12,2,11 |
||
| z2-3 (AU1) - z2-10 (EAU) | No switch pushed | 95 to 105 kΩ |
| z2-3 (AU1) - z2-10 (EAU) | Seek+ switch pushed | Below 2.5 Ω |
| z2-3 (AU1) - z2-10 (EAU) | Seek- switch pushed | 313 to 345 Ω |
| z2-3 (AU1) - z2-10 (EAU) | Volume+ switch pushed | 950 to 1050 Ω |
| z2-3 (AU1) - z2-10 (EAU) | Volume- switch pushed | 2955 to 3265 Ω |
| z2-9 (AU2) - z2-10 (EAU) | No switch pushed | 95 to 105 kΩ |
| z2-9 (AU2) - z2-10 (EAU) | MODE switch pushed | Below 2.5 Ω |
| z2-9 (AU2) - z2-10 (EAU) | On/off hook switch pushed | 950 to 1050 Ω |
| z2-9 (AU2) - z2-10 (EAU) | Voice switch pushed | 2955 to 3265 Ω |
| z2-5 (+DP2) - z2-10 (EAU) | No switch pushed | 95 to 105 kΩ |
| z2-5 (+DP2) - z2-10 (EAU) | Left switch pushed | Below 2.5 Ω |
| z2-5 (+DP2) - z2-10 (EAU) | Up switch pushed | 313 to 345 Ω |
| z2-5 (+DP2) - z2-10 (EAU) | Down switch pushed | 950 to 1050 Ω |
| z2-5 (+DP2) - z2-10 (EAU) | Right switch pushed | 2955 to 3265 Ω |
| z2-4 (+DP) - z2-10 (EAU) | No switch pushed | 95 to 105 kΩ |
| z2-4 (+DP) - z2-10 (EAU) | OK switch pushed | Below 2.5 Ω |
| z2-4 (+DP) - z2-10 (EAU) | Back switch pushed | 313 to 345 Ω |
| z2-8 (DIST) - z2-12 (ECC)*1 | No switch pushed | 1 MΩ or higher |
| z2-8 (DIST) - z2-12 (ECC)*1 | Distance control switch pushed | Below 2.5 Ω |
| z2-8 (DIST) - z2-12 (ECC)*1 | Lane tracing assist switch pushed | 228 to 252 Ω |
| z2-2 (CCS) - z2-12 (ECC)*1 | No switch pushed | 1 MΩ or higher |
| z2-2 (CCS) - z2-12 (ECC)*1 | Cruise control main switch pushed | Below 2.5 Ω |
| z2-2 (CCS) - z2-12 (ECC)*1 | CANCEL switch pushed | 228 to 252 Ω |
| z2-2 (CCS) - z2-12 (ECC)*1 | +RES switch pushed | 599 to 661 Ω |
| z2-2 (CCS) - z2-12 (ECC)*1 | -SET switch pushed | 1463 to 1617 Ω |
| z2-11 (ASL) - z2-12 (ECC)*2 | ASL switch pushed | Below 2.5 Ω |
If the result is not as specified, replace the steering pad switch assembly.
Check the illumination.
Apply auxiliary battery voltage to the steering pad switch assembly and check that the illumination.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(z2)Location & Routingewd_type=routing;type=c;code=z2 Click Connector(z2)Instrument Panel>other>Steering Pad Switch Assembly , Spiral Cable Sub-Assemblyewd_type=component;type=c;code=z2;pinno=1,6 |
||
| z2-1 (ILL+2) - z2-6 (ILL-) | z2-1 (ILL+2) - Auxiliary battery positive (+)
z2-6 (ILL-) - Auxiliary battery negative (-) |
The steering pad switch assembly illumination illuminates. |
If the result is not as specified, replace the steering pad switch assembly.