84255
1.INSPECT STEERING HEATER SWITCH
Check the resistance.
| *a | Component without harness connected
(Steering Heater Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H57)Location & Routingewd_type=routing;type=c;code=H57 Click Connector(H57)Instrument Panel>Instrument Panel Wire / Speaker Wire>Steering Heater Switchewd_type=component;type=c;code=H57;pinno=5,2 |
||
| H57-5(IG) - H57-2(B) | Steering heater switch is pushed | Below 1 Ω |
| H57-5(IG) - H57-2(B) | Steering heater switch is not pushed | 10 kΩ or higher |
If the result is not as specified, replace the steering heater switch.
Check the indicator.
| *a | Component without harness connected
(Steering Heater Switch) |
Apply auxiliary battery voltage to the steering heater switch and check that the indicator illuminates.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H57)Location & Routingewd_type=routing;type=c;code=H57 Click Connector(H57)Instrument Panel>Instrument Panel Wire / Speaker Wire>Steering Heater Switchewd_type=component;type=c;code=H57;pinno=2,4 |
||
| H57-2(B) - H57-4(E) | H57-2 (B) → Auxiliary battery positive (+)
H57-4 (E) → Auxiliary battery negative (-) |
Indicator illuminates |
If the result is not as specified, replace the steering heater switch.
Check the illumination.
| *a | Component without harness connected
(Steering Heater Switch) |
Apply auxiliary battery voltage to the steering heater switch and check that the illumination.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H57)Location & Routingewd_type=routing;type=c;code=H57 |
||
| H57-6(ILL+) - H57-1(ILL-) | H57-6 (ILL+) → Auxiliary battery positive (+)
H57-1 (ILL-) → Auxiliary battery negative (-) |
Illumination illuminates |
If the result is not as specified, replace the steering heater switch.