31250
1.INSPECT CLUTCH DISC ASSEMBLY
| *a | Facing |
| *b | Rivet |
| *c | Rivet Head Depth |
Using a vernier caliper, measure the rivet head depth.
| Specified Condition |
|---|
| 0.3 mm or higher |
| 0.0118 in. or higher |
If the result is not as specified, replace the clutch disc assembly.
Install the clutch disc assembly to the manual transaxle assembly.
Insert the clutch disc assembly in the correct direction.
Using a dial indicator, measure the clutch disc assembly runout.
| Specified Condition |
|---|
| 0.8 mm or less |
| 0.0315 in. or less |
If the result is not as specified, replace the clutch disc assembly.
31210
2.INSPECT CLUTCH COVER ASSEMBLY
| *a | Width |
| *b | Depth |
Using a vernier caliper, measure the depth and width of the diaphragm spring wear.
| Specified Condition |
|---|
| 0.5 mm or less |
| 0.0197 in. or less |
| Specified Condition |
|---|
| 6.0 mm or less |
| 0.236 in. or less |
If the result is not as specified, replace the clutch cover assembly.
13405
3.INSPECT FLYWHEEL SUB-ASSEMBLY
Using a dial indicator, check the flywheel sub-assembly runout.
| Specified Condition |
|---|
| 0.1 mm or less |
| 0.00394 in. or less |
If the result is not as specified, replace the flywheel sub-assembly.