Home › General › SPECIFICATIONS › CLUTCH › from 2021.07
RM3700E _V1 General _093022 SPECIFICATIONS _0480202 CLUTCH F

SPECIFICATIONS  CLUTCH  SERVICE DATA  


Clutch Pedal (for LHD)
Clutch pedal height from floor panel Standard height 154.6 to 174.6 mm (6.09 to 6.87 in.)
Clutch pedal free play Reference 3 to 15 mm (0.118 to 0.591 in.)
Clutch pedal stroke end position to release point Standard distance 25 mm (0.984 in.) or more
Clutch pedal stroke at 200 N (20 kgf, 45.0 lbf) Reference 141 to 151 mm (5.55 to 5.94 in.)

Clutch Pedal (for RHD)
Clutch pedal height from floor panel Standard height 158.1 to 178.1 mm (6.22 to 7.01 in.)
Clutch pedal free play Reference 3 to 15 mm (0.118 to 0.591 in.)
Clutch pedal stroke end position to release point Standard distance 25 mm (0.984 in.) or more
Clutch pedal stroke at 200 N (20 kgf, 45.0 lbf) Reference 141 to 151 mm (5.55 to 5.94 in.)

Clutch Stroke Sensor (for LHD)
GTS display Condition Specified condition
Clutch stroke sensor voltage Clutch pedal fully released 0.96 to 1.04 V
Not depressed → Fully depressed (Clutch pedal should be operated slowly) Value changes progressively (Only increase)

Clutch Stroke Sensor (for RHD)
GTS display Condition Specified condition
Clutch stroke sensor voltage Clutch pedal fully released 0.96 to 1.04 V
Not depressed → Fully depressed (Clutch pedal should be operated slowly) Value changes progressively (Only increase)

Clutch Unit
Clutch disc assembly rivet head depth - 0.3 mm (0.0118 in.) or higher
Clutch disc assembly runout - 0.8 mm (0.0315 in.) or less
Clutch cover assembly diaphragm spring wear Depth 0.5 mm (0.0197 in.) or less
Width 6.0 mm (0.236 in.) or less
Flywheel sub-assembly runout - 0.1 mm (0.00394 in.) or less
Clutch cover assembly diaphragm spring tip alignment Non-alignment 0.5 mm (0.0197 in.) or less

Clutch Pedal Switch
Clutch start switch assembly On (Pushed in) Below 1 Ω
Off (Released) 10 kΩ or higher

Brake Fluid
- SAE J1704 or FMVSS No. 116 DOT4