COMBINATION METER ASSEMBLY
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H6-1 (B) - Body ground | Auxiliary battery | Ignition switch off | 11 to 14 V |
| H6-9 (CANH) | CAN communication line | - | - |
| H6-10 (MSCL) | Local bus communication line | - | - |
| H6-11 (TX1-) - Body ground | Outside temperature sensor signal | - | - |
| H6-14 (FV) - Body ground | Fuel sender gauge (Power source) | Ignition switch ON | Pulse generation
(See waveform 1) |
| H6-15 (MSTI) - Body ground | Steering pad switch signal | Ignition switch ON, up, down, right and left switches on steering pad switch not pushed | 4.8 to 5.2 V |
| H6-16 (TX1+) - Body ground | Outside temperature sensor signal | - | - |
| H6-19 (EP) - Body ground | Ground | Always | Below 1 Ω |
| H6-20 (SI) - Body ground | Speed signal for other system (Input) | Ignition switch ON, wheel being rotated | Pulse generation
(See waveform 2) |
| H6-22 (B) - Body ground | Auxiliary battery | Ignition switch off | 11 to 14 V |
| H6-23 (ES) - Body ground | Ground | Always | Below 1 Ω |
| H6-24 (FE&B) -Body ground | Fuel sender gauge (Ground) | Always | Below 1 Ω |
| H6-25 (CANL) | CAN communication line | - | - |
| H6-27 (MSCH) | Local bus communication line | - | - |
| H6-31 (FR) - H6-24 (FE&B) | Fuel level signal | Ignition switch ON, fuel level full → low (fuel level warning light on) | Pulse generation
(See waveform 3) |
| H6-32 (MSM+) - Body ground | Steering pad switch signal | Ignition switch On, OK and back switches on steering pad switch not pushed | 4.8 to 5.2 V |
| H6-35 (A) - Body ground*2 | Steering vibration signal | Ignition switch ON, steering vibration off → ON | Below 1 V → 11 to 14 V |
| H6-36 (+S) - Body ground | Speed signal for other systems (Output) | Ignition switch ON, wheel being rotated | Pulse generation
(See waveform 2) |
| H6-38 (IG+) - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V*3
10.5 to 16 V*4 |
||
| H7-1 (LL) - Body ground | LH turn signal | LH turn indicator light off → blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| H7-2 (LR) - Body ground | RH turn signal | RH turn indicator light off → blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| H7-5 (TRNL) - Body ground | LH turn signal | LH turn indicator light off → blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| H7-6 (TRNR) - Body ground | RH turn signal | RH turn indicator light off → blinking | Below 1 V → 11 to 14 V ←→ Below 1 V |
| H7-7 (LP) - Body ground | Security indicator signal | Security indicator light off → blinking | Below 2 V → Pulse generation |
| H7-16 (SW) - Body ground*1 | Brake fluid level signal | Ignition switch ON, brake fluid level not low (brake warning light off) → low (brake warning light on) | 11 to 14 V → Below 1 V |
| H7-17 (HAZ) - Body ground | Hazard warning signal switch signal | Hazard warning signal switch off → on | 11 to 14 V → Below 1 V |
| H7-31 (OILW) - Body ground | Engine oil level signal | Ignition switch ON, engine oil level not low → low | Below 1 V → 11 to 14 V |
| H7-32 (VCM) - Body ground*1 | Vacuum warning switch signal | Engine started, vacuum warning switch off (brake warning light off) → on (brake warning light on) | 11 to 14 V → Below 1 V |
| H7-34 (BKL) - Body ground | Front passenger seat belt warning signal | Ignition switch ON, front passenger seat belt unfastened → fastened | Below 1 V → 11 to 14 V |
*1: for M15A-FKS
*2: w/ Advanced Driver Assistance System
*3: w/o Stop and Start System
*4: w/ Stop and Start System
| Item | Condition |
|---|---|
| Tester connection | H6-14 (FV) - Body ground |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Condition | Ignition switch ON |
| Specified Condition | 4.5 to 5.5 V |
| Item | Condition |
|---|---|
| Tester connection | ·
H6-20 (SI) - Body ground ·
H6-36 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Ignition switch ON, wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
| Item | Condition |
|---|---|
| Tester connection | H6-31 (FR) - H6-24 (FE&B) |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Condition | Ignition switch ON, fuel level full → low (fuel level warning light on) |
(A) varies depending on the fuel level.
Fuel level full: 4.2 to 4.6 V
Fuel level low (fuel level warning light on): 0.3 to 1.1 V