84210
1.INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
| *a | Push |
| *b | Release |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D48)Location & Routingewd_type=routing;type=c;code=D48 Click Connector(D48)Engine Compartment>Engine Wire>Back-Up Light Switch Assemblyewd_type=component;type=c;code=D48;pinno=1,2 |
||
| D48-1 (RL) - D48-2 (RB) | Pushed | Below 1 Ω |
| D48-1 (RL) - D48-2 (RB) | Released | 10 kΩ or higher |
If the result is not as specified, replace the back-up light switch assembly.