41300
1.INSPECT FRONT DIFFERENTIAL CASE WITH RING GEAR ASSEMBLY
Using SST, rotate the front differential side gear as shown in the illustration.
The front differential side gear does not lock when rotated in either direction.
If the front differential side gear locks, perform all inspections.
If the front differential side gear still locks even after replacing the malfunctioning parts, replace the front differential case with ring gear assembly.
2.INSPECT FRONT DIFFERENTIAL SIDE GEAR THRUST AMOUNT
Secure the front differential case with ring gear assembly in a vise between aluminum plates.
Do not overtighten the vise.
Using SST and a dial indicator, measure the front differential side gear thrust amount.
Measure the front differential side gear thrust amount while slowly rotating the front differential side gear.
Make sure to measure the front differential side gear thrust amount for both of the 2 front differential side gears.
| Specified Condition |
|---|
| 0.08 mm or less |
| 0.00315 in. or less |
If the result is not as specified, replace the 2 front differential side gears, 2 front differential pinions and 2 center differential side gear conical spring washers.
3.INSPECT FRONT DIFFERENTIAL PINION BACKLASH
Install SST as shown in the illustration and tighten it.
| *a | Hold | - | - |
|
Turn | - | - |
Secure the front differential case with ring gear assembly in a vise between aluminum plates.
Do not overtighten the vise.
| *1 | Front No. 1 Differential Pinion Shaft |
Install the front No. 1 differential pinion shaft to the front differential pinion as shown in the illustration.
Using a dial indicator, measure the front differential pinion backlash.
| Specified Condition |
|---|
| 0.20 mm or less |
| 0.00787 in. or less |
If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers with washers of a different thickness. Use the table below to select a front No. 1 differential side gear thrust washer which will ensure that the backlash is within the specification.
| Mark | Thickness | Mark | Thickness |
|---|---|---|---|
| 19 | 0.90 mm (0.0354 in.) | 03 | 1.10 mm (0.0433 in.) |
| 14 | 0.95 mm (0.0374 in.) | 16 | 1.15 mm (0.0453 in.) |
| 02 | 1.00 mm (0.0394 in.) | 04 | 1.20 mm (0.0472 in.) |
| 15 | 1.05 mm (0.0413 in.) | - | - |
Select front No. 1 differential side gear thrust washers of the same thickness for both the right and left side.
4.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
| Specified Condition |
|---|
| 0.92 mm or higher |
| 0.0362 in. or higher |
Measure the most worn portion of the front differential pinion thrust washer.
If the result is not as specified, replace the front differential pinion thrust washer.
5.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.
| Specified Condition |
|---|
| 16.982 mm or higher |
| 0.669 in. or higher |
Measure the most worn portion of the front No. 1 differential pinion shaft.
If the result is not as specified, replace the front No. 1 differential pinion shaft.