1. OPERATION CHECK
| *a | Retainer |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
Be sure to disconnect the No. 1 vacuum hose connector by hand.
| *a | Vacuum Gauge |
| *b | Plug |
Connect the hose of the vacuum gauge to the vacuum pump assembly.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the vacuum of the vacuum pump assembly.
More than 86.7 kPa (650 mmHg, 25.6 in.Hg)
If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.
Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (except BOSCH Made)>DISASSEMBLY
Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.
Remove the vacuum gauge from the vacuum pump assembly.
Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.