Stop and start control can be disabled by pressing the stop and start system cancel switch (combination switch assembly). The stop and start system cancel switch (combination switch assembly) is a momentary-type switch that switches between on and off when the switch is pressed. While stop and start control is disabled, the stop and start cancel indicator is illuminated to inform the driver.
Enter the following menus.
| Tester Display |
|---|
| Stop&Start Cancel Switch |
Read the value when the stop and start system cancel switch (combination switch assembly) is pressed.
| GTS Display | Condition | Normal Condition |
|---|---|---|
| Stop&Start Cancel Switch | Stop and start system cancel switch (combination switch assembly) is pressed | ON |
| Stop and start system cancel switch (combination switch assembly) is not pressed | OFF |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY>REMOVAL
Disconnect the H18 stop and start system cancel switch (combination switch assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H18)Location & Routingewd_type=routing;type=c;code=H18 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=5 |
||
| H18-5 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H43 engine stop and start ECU connector.
Disconnect the H18 stop and start system cancel switch (combination switch assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H43,H18)Location & Routingewd_type=routing;type=c,c;code=H43,H18 Click Connector(H43)Instrument Panel>Instrument Panel Wire / Speaker Wire>Engine Stop and Start ECUewd_type=component;type=c;code=H43;pinno=5 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=6 |
||
| H43-5 (ECAN) - H18-6 (ECU) | Always | Below 1 Ω |
| H43-5 (ECAN) - Body ground and other terminals | Always | 10 kΩ or higher |
| H18-6 (ECU) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG