DESCRIPTION
The engine stop and start ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
Freeze frame data values will vary depending on the measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.
Turn the ignition switch to ON and park the vehicle on level ground. Check the freeze frame data using the GTS.
Check for DTCs and read the freeze frame data.
LIST OF FREEZE FRAME DATA
| Tester Display |
|---|
| Total Distance Traveled |
| Total Distance Traveled - Unit |
| Neutral Switch |
| IG Switch |
| Stop Light SW (ECM) |
| Stop Light SW (ABS/VSC) |
| Driver Courtesy Switch Signal |
| Hood Courtesy Switch |
| Stop&Start Cancel Switch |
| Starter |
| Engine Starter Signal |
| Driver Seat Belt Buckle Switch |
| Engine Speed (ECM) |
| Battery Current |
| Brake Boost Pressure |
| Brake Negative Pressure |
| Gradient of Road Surface |
| Battery Fluid Temperature (Start) |
| Battery Fluid Temperature |
| Buzzer |
| Oil Pressure Warning Light Prohibit |
| Stop&Start Operating Permission (Neutral Switch) |
| Stop&Start Operating Permission (Vehicle Speed) |
| Stop&Start Precondition |
| Stop&Start Precondition 2 |
| Hill Judging |
| IG-ON State Before Starting |
| Engine Start Request (Brake Negative Pressure Low) |
| Engine Start Request (ABS Vehicle Speed) |
| Engine Start Request (Steering) |
| Engine Start Request (Cancel SW) |
| Engine Start Request (IG Switch) |
| Engine Start Request (A/C) |
| Engine Start Request (Battery Condition) |
| Engine Start Request (ECM) |
| Engine Start Request (Detect DTC) |
| Engine Stall History during Stop&Start (Hood Open) |
| Engine Stall History during Stop&Start (Collision or Battery Voltage Low) |
| Engine Stall History during Engine Starting (Collision) |
| Engine Start Fail |
| Starter Operation # |
| Number of Engine Starts (IG-ON) |
| Number of Engine Starts (Stop & Start) |
| Stop&Start of Engine State |
| Idling Stop Rate |
| Total Idling Stop Rate |
| Stop & Start A/C Mode |
| Integrated Current |
| Status of Battery Charge Control |
| Cranking Time |
| Minimum Voltage (Cranking) |
| Minimum Voltage (Starter Solenoid Engagement) |
| State of BBC |
| State of External BBC |
| External BBC Overcurrent History |
| Stop&Start Operating Permission (Idling) |
| Stop&Start Operating Permission (Brake Negative Pressure) |
| Stop&Start Operating Permission (After Running) |
| Stop&Start Operating Permission (Steering) |
| Stop&Start Operating Permission (Engine Hood Closed) |
| Stop&Start Operating Permission (Cancel Switch) |
| Stop&Start Operating Permission (Driver Side Buckle SW) |
| Stop&Start Operating Permission (Driver Door Closed) |
| Stop&Start Operating Permission (Key Operation) |
| Stop&Start Operating Permission (Interval For Starter) |
| Stop&Start Operating Permission (Starter Check Complete) |
| Stop&Start Operating Permission (A/C) |
| Stop&Start Operating Permission (Power Management) |
| Stop&Start Operating Permission (ECM 2) |
| Stop&Start Operating Permission (ECM 1) |
| Stop&Start Operating Permission (Elapsed Time After IG-ON) |
| Stop&Start Operating Permission (Idling Stop Performance Waiting Time) |
| Stop&Start Operating Permission (Ambient Temperature) |
| Stop&Start Operating Permission (Road Surface Gradient) |
| Stop&Start Operating Permission (DTC) |
| Stop&Start Operating Permission (Minimum Voltage (Starter Solenoid Engagement)) |
| Stop&Start Operating Permission (Minimum Voltage (Cranking)) |
| EPS Load |
| Steering Angle |
| Steering Angle Velocity |
| Engine Stop Request |
| Stop&Start Cancel |
| Auto A/C |
| Running History |
| Wheel Speed Malfunction |
| Fuel Cut Signal |
| Idle |
| Engine Start (IG SW) |
| Engine Start Request (Courtesy SW or Buckle SW) |
| Stop&Start Operating Permission (Integrated Current) |
| Stop&Start Operating Prohibition (Jump Start) |
| ABS Running |
| Engine Type Information |
| Steering Angle Sensor Malfunction |
| Steering Angle Sensor Circuit Open (+B) |
| Steering Angle Sensor Abnormal Value |
| Steering Torque Sensor Malfunction |
| Battery Type |
| Steering Wheel Torque |
| Air Suspension Available |
| Welcab Available |
| External BBC Available |
| Brake Hold Function Available |
| Steering Angle Sensor Available |
| 4WD Available |
| PCS Available |
| Communication Method of Brake Boost Sensor |
| IPA Available |
| Cancel Switch (Multi-display) Available |
| Coolant Temperature |
| Engine Speed |
| Vehicle Speed |
| Atmospheric Pressure |
| Battery Voltage |
| Ambient Temperature |
| Engine Start Request (Clutch Pedal ON) |
| Engine Start Request (Clutch Lower Switch ON) |
| Stop&Start Operating Permission (Manual Start) |
| Stop&Start Operating Permission (Clutch) |
| Stop&Start Operating Permission (Shift Position) |
| ECB Available |
| Learning Status of External BBC Availability |
| ICS Available |
| LVN Available |
| RSA Available |
| Clutch Lower Switch |
| N Position Switch Signal Voltage |
| Alternator Status |
| Number of Engine Starts (Clutch Released) |
| Number of Engine Starts (Clutch Half-Depressed) |
| Wrong Operation (Start) |
| Manual Start History during Stop&Start |
| N/Clutch Lower Switch Malfunction |
| N/Clutch Upper Switch Malfunction |
| Stop&Start Operating Prohibition (Manual Start for the First Time) |
| Clutch Status |
| Clutch Stroke Sensor Malfunction |
| IG Switch (ECM) |
| Stop&Start ECU Substrate Temperature 1 |
| Stop&Start ECU Substrate Temperature 2 |
| Brake Booster Pressure Sensor Voltage |
| Starter Circuit Monitor Voltage |
| BBC Output Voltage (for B41 Connected Load) |
| BBC Output Voltage (for B42 Connected Load) |
| BBC Output Voltage (for B43 Connected Load) |
| BBC Output Voltage (for IG41 Connected Load) |
| Stop&Start Lamp Lighting Request Status |
| Clutch Stroke Position |