81080V
1.INSPECT NO. 2 INTERIOR ILLUMINATION LIGHT ASSEMBLY
Check that the LED illuminates. (for LH Side)
| *a | Component without harness connected
(No. 2 Interior Illumination Light Assembly) |
Apply auxiliary battery voltage to the No. 2 interior illumination light assembly and check that the LED illuminates.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H11)Location & Routingewd_type=routing;type=c;code=H11 |
||
| H11-2 (B) - H11-1 (E) | H11-2 (B) → Auxiliary battery positive (+)
H11-1 (E) → Auxiliary battery negative (-) |
LED illuminates |
If the result is not as specified, replace the No. 2 interior illumination light assembly.
Check that the LED illuminates. (for RH Side)
| *a | Component without harness connected
(No. 2 Interior Illumination Light Assembly) |
Apply auxiliary battery voltage to the No. 2 interior illumination light assembly and check that the LED illuminates.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H13)Location & Routingewd_type=routing;type=c;code=H13 |
||
| H13-2 (B) - H13-1 (E) | H13-2 (B) → Auxiliary battery positive (+)
H13-1 (E) → Auxiliary battery negative (-) |
LED illuminates |
If the result is not as specified, replace the No. 2 interior illumination light assembly.
81080M
2.INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
Check that the LED illuminates. (for LH Side)
| *a | Component without harness connected
(No. 1 Interior Illumination Light Assembly) |
Apply auxiliary battery voltage to the No. 1 interior illumination light assembly and check that the LED illuminates.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H10)Location & Routingewd_type=routing;type=c;code=H10 |
||
| H10-2 (B) - H10-1 (E) | H10-2 (B) → Auxiliary battery positive (+)
H10-1 (E) → Auxiliary battery negative (-) |
LED illuminates |
If the result is not as specified, replace the No. 1 interior illumination light assembly.
Check that the LED illuminates. (for RH Side)
| *a | Component without harness connected
(No. 1 Interior Illumination Light Assembly) |
Apply auxiliary battery voltage to the No. 1 interior illumination light assembly and check that the LED illuminates.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H12)Location & Routingewd_type=routing;type=c;code=H12 |
||
| H12-2 (B) - H12-1 (E) | H12-2 (B) → Auxiliary battery positive (+)
H12-1 (E) → Auxiliary battery negative (-) |
LED illuminates |
If the result is not as specified, replace the No. 1 interior illumination light assembly.