Home › Drivetrain › EC6D (MANUAL TRANSMISSION / TRANSAXLE) › SPEED SENSOR › from 2021.07
RM3700E _52 Drivetrain _104886 EC6D MANUAL TRANSMISSION / TRANSAXLE _0482073 SPEED SENSOR G

EC6D MANUAL TRANSMISSION / TRANSAXLE  SPEED SENSOR  INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 89413B 1.INSPECT TRANSMISSION REVOLUTION SENSOR

Pre-procedure1

a.

Connect the battery to the sensor as shown in the illustration.

C462145C01
4.802,0.417 6.844,2.365 2.042,1.948 5.583,0.5 6.083,0.75 0.5,0.25 3.542,0.552 3.844,0.552 false 2.115,0.646 2.115,0.542 false 5.406,2.031 5.656,2.031 5.656,2.031 5.656,1.583 true 6.292,2.021 6,2.021 6,2.021 6,1.594 true 0.719,2.073 0.719,1.854 false 0.656,0.25 0.896,0.417 0.24,0.167 10 false *b 2.083,0.656 2.313,1.031 0.229,0.375 10 false 2 3.896,0.448 3.99,0.594 0.094,0.146 10 false 1 0.656,2.115 0.844,2.281 0.188,0.167 10 false *1 2.833,1.958 3.052,2.167 0.219,0.208 10 false *d 3.75,1.698 3.938,1.906 0.188,0.208 10 false *c 4.896,0.51 5.083,0.719 0.188,0.208 10 false *a 5.667,0.542 6.083,0.74 0.417,0.198 10 false D109 5.063,1.938 5.521,2.135 0.458,0.198 10 false NMB 6.344,1.938 6.802,2.135 0.458,0.198 10 false NMO
*1 Auxiliary Battery - -
*a Component without harness connected
(Transmission Revolution Sensor)
*b Ammeter
*c Magnet *d 5 mm or less



b.

Wave a magnetic object left and right in front of the transmission revolution sensor tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

NOTICE:

Make sure to wave the magnetic object during the inspection. The current will not change without waving the magnetic object as indicated by the arrow in the illustration.



Procedure1

a.

Measure the current according to the value(s) in the table below.

Standard Current:
Tester Connection Condition Specified Condition

Click Location & Routing(D109)Location & Routing

Click Connector(D109)Engine Compartment>Engine Wire>Transmission Revolution Sensor

D109-1 (NMO) - D109-2 (NMB) Low signal 4 to 8 mA
D109-1 (NMO) - D109-2 (NMB) High signal 12 to 16 mA



b.

If the result is not as specified, replace the transmission revolution sensor.


Post-procedure1

a.

None