84970
1.INSPECT COMBINATION SWITCH ASSEMBLY (iMT SWITCH)
Check the resistance.
| *a | Component without harness connected
(Combination Switch Assembly (iMT Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H18)Location & Routingewd_type=routing;type=c;code=H18 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=8,5 |
||
| H18-8 (IG) - H18-5 (E) | iMT switch pushed | Below 1 Ω |
| H18-8 (IG) - H18-5 (E) | iMT switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch assembly (iMT switch).
Check that the illumination illuminates.
| *a | Component without harness connected
(Combination Switch Assembly (iMT Switch)) |
Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly (iMT switch).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H18)Location & Routingewd_type=routing;type=c;code=H18 Click Connector(H18)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Switch Assemblyewd_type=component;type=c;code=H18;pinno=4,1 |
||
| H18-4 (ILL+) - H18-1 (ILL-) | H18-4 (ILL+) - Auxiliary battery positive (+)
H18-1 (ILL-) - Auxiliary battery negative (-) |
Combination switch assembly (iMT switch) illumination illuminates. |
If the result is not as specified, replace the combination switch assembly (iMT switch).