84794
1.INSPECT FRONT WIPER DEICER SWITCH
Check the resistance.
| *a | Component without harness connected
(Front Wiper Deicer Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H151)Location & Routingewd_type=routing;type=c;code=H151 Click Connector(H151)Instrument Panel>Instrument Panel Wire / Speaker Wire>Front Wiper Deicer Switchewd_type=component;type=c;code=H151;pinno=2,5 |
||
| H151-2(E) - H151-5(IG) | Front wiper deicer switch off | 10 kΩ or higher |
| H151-2(E) - H151-5(IG) | Front wiper deicer switch on | Below 1 Ω |
If the result is not as specified, replace the front wiper deicer switch.
Check the illumination.
| *a | Component without harness connected
(Front Wiper Deicer Switch) |
| *b | Illuminates |
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Battery Connection | Specified Condition |
|---|---|
| H151-6(ILL+) - Auxiliary battery positive
H151-1(ILL-) - Auxiliary battery negative |
Illuminates |
If the result is not as specified, replace the front wiper deicer switch.
Check the indicator light illuminates.
| *a | Component without harness connected
(Front Wiper Deicer Switch) |
| *b | Indicator light |
Apply auxiliary battery voltage to the connector and check the illumination conditions.
| Battery Connection | Specified Condition |
|---|---|
| H151-5(IG) - Auxiliary battery positive
H151-4(D) - Auxiliary battery negative |
Illuminates |
If the result is not as specified, replace the front wiper deicer switch.