Home › Drivetrain › EC6D (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › from 2021.07
RM3700E _52 Drivetrain _104886 EC6D MANUAL TRANSMISSION / TRANSAXLE _0482438 MANUAL TRANSAXLE SYSTEM D

EC6D MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using GTS)


a.

Enter the following menus:

Powertrain > Engine > Trouble Codes
50001 372

b.

According to the display in the GTS, read the DTCs and freeze frame data and make a note of them.




CLEAR DTC (Using GTS)


a.

Enter the following menus:


b.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372


CLEAR DTC (When Not Using GTS)


a.

Perform either of the following operations:

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE


·

Disconnect the cable from the negative (-) auxiliary battery terminal for more than 1 minute.

·

Remove the EFI NO. 1 fuse from the No. 1 engine room relay block located inside the engine compartment for more than 1 minute.