89341L
1.INSPECT FRONT CENTER ULTRASONIC SENSOR (for LH Side)
Check the resistance.
| *a | Component without harness connected
(Front Center Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B2)Location & Routingewd_type=routing;type=c;code=B2 Click Connector(B2)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Center LHewd_type=component;type=c;code=B2;pinno=4,6,1,5,2,3 |
||
| B2-4 (BI) - B2-6 (EI) | Always | 10 kΩ or higher |
| B2-4 (BI) - B2-1 (BO) | Always | Below 1 Ω |
| B2-5 (SI) - B2-2 (SO) | Always | Below 15 Ω |
| B2-6 (EI) - B2-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the front center ultrasonic sensor.
89341L
2.INSPECT FRONT CENTER ULTRASONIC SENSOR (for RH Side)
Check the resistance.
| *a | Component without harness connected
(Front Center Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B3)Location & Routingewd_type=routing;type=c;code=B3 Click Connector(B3)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Center RHewd_type=component;type=c;code=B3;pinno=4,6,1,5,2,3 |
||
| B3-4 (BI) - B3-6 (EI) | Always | 10 kΩ or higher |
| B3-4 (BI) - B3-1 (BO) | Always | Below 1 Ω |
| B3-5 (SI) - B3-2 (SO) | Always | Below 15 Ω |
| B3-6 (EI) - B3-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the front center ultrasonic sensor.
89341K
3.INSPECT FRONT CORNER ULTRASONIC SENSOR (for LH Side)
Check the resistance.
| *a | Component without harness connected
(Front Corner Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B1)Location & Routingewd_type=routing;type=c;code=B1 Click Connector(B1)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Corner LHewd_type=component;type=c;code=B1;pinno=4,6,1,5,2,3 |
||
| B1-4 (BI) - B1-6 (EI) | Always | 10 kΩ or higher |
| B1-4 (BI) - B1-1 (BO) | Always | Below 1 Ω |
| B1-5 (SI) - B1-2 (SO) | Always | Below 15 Ω |
| B1-6 (EI) - B1-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the front corner ultrasonic sensor.
89341K
4.INSPECT FRONT CORNER ULTRASONIC SENSOR (for RH Side)
Check the resistance.
| *a | Component without harness connected
(Front Corner Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B4)Location & Routingewd_type=routing;type=c;code=B4 Click Connector(B4)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Corner RHewd_type=component;type=c;code=B4;pinno=4,6,5 |
||
| B4-4 (BI) - B4-6 (EI) | Always | 10 kΩ or higher |
| B4-4 (BI) - B4-[1] | Always | Below 1 Ω |
| B4-5 (SI) - B4-[2] | Always | Below 15 Ω |
| B4-6 (EI) - B4-[3] | Always | Below 1 Ω |
If the result is not as specified, replace the front corner ultrasonic sensor.
89341M
5.INSPECT FRONT SIDE ULTRASONIC SENSOR (for LH Side)
Check the resistance.
| *a | Component without harness connected
(Front Side Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B16)Location & Routingewd_type=routing;type=c;code=B16 Click Connector(B16)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Side LHewd_type=component;type=c;code=B16;pinno=4,6,1,5,2,3 |
||
| B16-4 (BI) - B16-6 (EI) | Always | 10 kΩ or higher |
| B16-4 (BI) - B16-1 (BO) | Always | Below 1 Ω |
| B16-5 (SI) - B16-2 (SO) | Always | Below 15 Ω |
| B16-6 (EI) - B16-3 (EO) | Always | Below 1 Ω |
If the result is not as specified, replace the front side ultrasonic sensor.
89341M
6.INSPECT FRONT SIDE ULTRASONIC SENSOR (for RH Side)
Check the resistance.
| *a | Component without harness connected
(Front Side Ultrasonic Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(B17)Location & Routingewd_type=routing;type=c;code=B17 Click Connector(B17)Engine Compartment>No. 3 Engine Room Wire>Front Ultrasonic Sensor Side RHewd_type=component;type=c;code=B17;pinno=4,6,5 |
||
| B17-4 (BI) - B17-6 (EI) | Always | 10 kΩ or higher |
| B17-4 (BI) - B17-[1] | Always | Below 1 Ω |
| B17-5 (SI) - B17-[2] | Always | Below 15 Ω |
| B17-6 (EI) - B17-[3] | Always | Below 1 Ω |
If the result is not as specified, replace the front side ultrasonic sensor.