| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | EGR VALVE WITH EGR COOLER ASSEMBLY | - | - | - | - |
| 2 | EGR PIPE GASKET | 25634 | - | - | - |
| 3 | EGR COOLER ASSEMBLY | 25680 | - | - | - |
| 4 | NO. 1 EGR COOLER GASKET | 25685 | - | - | - |
| 5 | EGR VALVE GASKET | 25627 | - | - | - |
| *1 | EGR VALVE ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE EGR VALVE WITH EGR COOLER ASSEMBLY
25634
2.REMOVE EGR PIPE GASKET
25680
3.REMOVE EGR COOLER ASSEMBLY
25685
4.REMOVE NO. 1 EGR COOLER GASKET
25627
5.REMOVE EGR VALVE GASKET