When the temperature sensor inside the electric brake booster (brake booster with master cylinder assembly) meets the detection conditions, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C13BA1C | Electronic Brake Booster Motor "A" Current Sensor Circuit Voltage Out of Range | Motor current sensor current abnormality is detected for 0.2 seconds or more. | Electric brake booster (brake booster with master cylinder assembly) | Brake Booster | A |
After replacing the electric brake booster (brake booster with master cylinder assembly), perform "Calibration" after performing "Reset Memory".
Inspect the fuses for circuits related to this system before performing the following procedure.
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for LHD | A |
| for RHD | B |
A
B
Procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Pre-procedure1
Disconnect the A34 electric brake booster (brake booster with master cylinder assembly) connector.
Procedure2
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Procedure3
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A34)Location & Routingewd_type=routing;type=c;code=A34 Click Connector(A34)Engine Compartment>Engine Room Main Wire>Brake Booster Control ECU (Brake Booster with Master Cylinder Assembly)ewd_type=component;type=c;code=A34;pinno=1 |
||
| A34-1 (+BS) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Procedure1
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Pre-procedure1
Disconnect the A35 electric brake booster (brake booster with master cylinder assembly) connector.
Procedure2
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Procedure3
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(A35)Location & Routingewd_type=routing;type=c;code=A35 Click Connector(A35)Engine Compartment>Engine Room Main Wire>Brake Booster Control ECU (Brake Booster with Master Cylinder Assembly)ewd_type=component;type=c;code=A35;pinno=1 |
||
| A35-1 (+BS) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG