The main relay is built into the electric brake booster (brake booster with master cylinder assembly).
When the electric brake booster (brake booster with master cylinder assembly) detects a malfunction in a circuit necessary for main relay to operate, or in the main relay itself, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C145D49 | Electronic Brake Booster Motor "A" Power Supply Circuit "A" Internal Electronic Failure | Main relay inside electric brake booster (brake booster with master cylinder assembly) stuck ON detected. | Electric brake booster (brake booster with master cylinder assembly) | Brake Booster | A |
| C145D71 | Electronic Brake Booster Motor "A" Power Supply Circuit "A" Actuator Stuck | Main relay inside electric brake booster (brake booster with master cylinder assembly) power source circuit condition detected. | Electric brake booster (brake booster with master cylinder assembly) | Brake Booster | A |
After replacing the electric brake booster (brake booster with master cylinder assembly), perform "Calibration" after performing "Reset Memory".
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for LHD | A |
| for RHD | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT