Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made) › from 2021.07
RM3700E _54 Brake _093745 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0483473 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made)  C148A1C  Electronic Brake Booster Motor "A" Temperature Sensor "A" Circuit Voltage Out of Range  C148F62  Electronic Brake Booster Motor Temperature "A" / "B" Signal Compare Failure  C149A1C  Electronic Brake Booster Motor "A" Temperature Sensor "B" Circuit Voltage Out of Range  


DESCRIPTION

When the temperature sensor inside the electric brake booster (brake booster with master cylinder assembly) meets the detection conditions, this DTC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C148A1C Electronic Brake Booster Motor "A" Temperature Sensor "A" Circuit Voltage Out of Range Temp sensor 1 output voltage is 3.27 V or more, or 0.2 V or less, for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster A
C148F62 Electronic Brake Booster Motor Temperature "A" / "B" Signal Compare Failure The sum of temp sensor 1 and temp sensor 2 output voltages is within the range of 3.17 V to 3.43 V for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster A
C149A1C Electronic Brake Booster Motor "A" Temperature Sensor "B" Circuit Voltage Out of Range Temp sensor 2 output voltage is 3.27 V or more, or 0.2 V or less, for 0.6 seconds or more. Electric brake booster (brake booster with master cylinder assembly) Brake Booster A

CAUTION / NOTICE / HINT

NOTICE:

After replacing the electric brake booster (brake booster with master cylinder assembly), perform "Calibration" after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>UTILITY


PROCEDURE

1.CHECK VEHICLE
a.

Check the vehicle specification.


Result:
Result Proceed to
for LHD A
for RHD B



A

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

B

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END

3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

NEXT

END