The electric brake booster (brake booster with master cylinder assembly) communicates with the following ECUs and sensors via CAN communication.
Hybrid vehicle control ECU
Inverter with converter assembly
Certification ECU (smart key ECU assembly)
Skid control ECU (brake actuator assembly)
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U011087 | Lost Communication with Drive Motor Control Module "A" Missing Message | When the IG terminal voltage is 10 V or more, data from the inverter with converter assembly cannot be received for 2 seconds or more. | ·
CAN communication system ·
Inverter with converter assembly ·
Electric brake booster (brake booster with master cylinder assembly) |
Brake Booster | B |
| U025E87 | Lost Communication with Electronic Brake Booster Control Module "A" Missing Message | When the IG terminal voltage is 10 V or more, communication between the electric brake booster (brake booster with master cylinder assembly) and the skid control ECU (brake actuator assembly) is abnormal for 2 seconds or more. | ·
CAN communication system ·
Electric brake booster (brake booster with master cylinder assembly) ·
Skid control ECU (brake actuator assembly) |
Brake Booster | B |
| U110787 | Lost Communication with Power Management Module Missing Message | When the IG terminal voltage is 10 V or more, data from the certification ECU (smart key ECU assembly) cannot be received for 3 seconds or more. | ·
CAN communication system ·
Certification ECU (smart key ECU assembly) ·
Electric brake booster (brake booster with master cylinder assembly) |
Brake Booster | B |
| U115887 | Lost Communication with Electronic Brake Booster Control Module "A" (ch2) Missing Message | When the IG terminal voltage is 10 V or more, electric brake booster (brake booster with master cylinder assembly) and skid control ECU (brake actuator assembly) communication malfunction occurs for 2 seconds or more. | ·
CAN communication system ·
Electric brake booster (brake booster with master cylinder assembly) ·
Skid control ECU (brake actuator assembly) |
Brake Booster | B |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Using the GTS to operate the Health Check.
| Result | Proceed to |
|---|---|
| DTCs for related systems are output together with U011087, U025E87, U110787 or U115887. | A |
| DTC U011087, U025E87, U110787 or U115887 is output. | B |
| DTCs are not output. | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING