The skid control ECU (brake actuator assembly) communicates with the following ECUs and sensors via CAN communication.
ECM
Engine stop and start ECU
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | When the voltage at terminal +BS is between 9.6 and 16.5 V, data cannot be received from the ECM for 3 second or more. | ·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
DTC stored | Brake/EPB | B | An electric parking brake system malfunction is displayed on the multi-information display. |
| U110387 | Lost Communication with Stop and Start Control Module Missing Message | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, data cannot be received from engine stop and start ECU continuously for 2 seconds or more. | ·
CAN communication system ·
Engine stop and start ECU ·
Skid control ECU (brake actuator assembly) |
DTC stored | Brake/EPB | B | An electric parking brake system malfunction is displayed on the multi-information display. |
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Perform a health check.
| Result | Proceed to |
|---|---|
| DTCs for related systems are output together with DTC U110387. | A |
| U010087 or U110387 is output. | B |
| DTCs are not output. | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING