The radio and display receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.
The sound signal that is sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in this circuit, sound cannot be heard from the speakers even if the stereo component amplifier assembly or speakers are not malfunctioning.
Disconnect the H83 radio and display receiver assembly connector.
Disconnect the H137 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H137,H83)Location & Routingewd_type=routing;type=c,c;code=H137,H83 Click Connector(H137)Instrument Panel>Instrument Panel Wire / Speaker Wire>Stereo Component Amplifier Assemblyewd_type=component;type=c;code=H137;pinno=5,4,3,2,6 Click Connector(H83)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assemblyewd_type=component;type=c;code=H83;pinno=1,6,2,7 |
||
| H137-5 (R+) - H83-1 (FR+) | Always | Below 1 Ω |
| H137-4 (R-) - H83-6 (FR-) | Always | Below 1 Ω |
| H137-3 (L+) - H83-2 (FL+) | Always | Below 1 Ω |
| H137-2 (L-) - H83-7 (FL-) | Always | Below 1 Ω |
| H137-6 (SLD) - Body ground | Always | 10 kΩ or higher |
| H137-5 (R+) - Body ground | Always | 10 kΩ or higher |
| H137-4 (R-) - Body ground | Always | 10 kΩ or higher |
| H137-3 (L+) - Body ground | Always | 10 kΩ or higher |
| H137-2 (L-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG