This circuit sends a charging suspension signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle assembly. Based on this signal, the mobile wireless charger cradle assembly suspends or resumes wireless charging.
The wireless charging system uses the same radio wave frequency that is used to perform verification of the electrical key transmitter sub-assembly. Therefore, when the electrical key transmitter sub-assembly verification is being performed, the certification ECU (smart key ECU assembly) sends a charging suspension signal to the wireless charging system to suspend charging.
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
| *a | Component with harness connected
(Mobile Wireless Charger Cradle Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H86)Location & Routingewd_type=routing;type=c;code=H86 Click Connector(H86)Instrument Panel>Instrument Panel Wire / Speaker Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=H86;pinno=7 |
||
| H86-7 (DIS) - Body ground | For 5 seconds after turning ignition switch from off to ACC*1 | 4.5 to 6.0 V |
| H86-7 (DIS) - Body ground | Device being charged | Below 1 V |
| H86-7 (DIS) - Body ground | Charging suspended due to entry and start system status*2 | 4.5 to 6.0 V |
*1: When the ignition switch is turned from off to ACC, the mobile wireless charger cradle assembly monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the ignition switch is turned from off to ACC again.
*2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal, refer to System Description.
Click hereVehicle Interior>POWER OUTLETS (INT)>WIRELESS CHARGING SYSTEM>SYSTEM DESCRIPTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O47 certification ECU (smart key ECU assembly) connector.
Disconnect the H86 mobile wireless charger cradle assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(O47,H86)Location & Routingewd_type=routing;type=c,c;code=O47,H86 Click Connector(O47)Instrument Panel>Floor Wire>Certification ECUewd_type=component;type=c;code=O47;pinno=20 Click Connector(H86)Instrument Panel>Instrument Panel Wire / Speaker Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=H86;pinno=7 |
||
| O47-20 (WCSW) - H86-7 (DIS) | Always | Below 1 Ω |
| O47-20 (WCSW) or H86-7 (DIS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG