When the taillight is on, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.
Inspect the fuse for circuits related to this system before performing the following procedure.
Disconnect the H86 mobile wireless charger cradle assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H86)Location & Routingewd_type=routing;type=c;code=H86 Click Connector(H86)Instrument Panel>Instrument Panel Wire / Speaker Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=H86;pinno=10 |
||
| H86-10 (TAIL) - Body ground | Light control switch in off position | Below 1 V |
| H86-10 (TAIL) - Body ground | Ignition switch off, light control switch in tail or head position | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H86 mobile wireless charger cradle assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H86)Location & Routingewd_type=routing;type=c;code=H86 Click Connector(H86)Instrument Panel>Instrument Panel Wire / Speaker Wire>Mobile Wireless Charger Cradle Assemblyewd_type=component;type=c;code=H86;pinno=9 |
||
| H86-9 (ILL-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG