69065A
1.INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY
| *a | Component without harness connected
(Airbag Cut Off Switch Cylinder Sub-assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H15)Location & Routingewd_type=routing;type=c;code=H15 Click Connector(H15)Instrument Panel>Instrument Panel Wire / Speaker Wire>Airbag Cut Off Switch Cylinder Sub-Assemblyewd_type=component;type=c;code=H15;pinno=2,1 |
||
| H15-2 (PMC+) - H15-1 (PMC-) | Cut off switch in ON position | 360 to 440 Ω |
| H15-2 (PMC+) - H15-1 (PMC-) | Cut off switch in OFF position | 90 to 110 Ω |
If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.