The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U010487 | Lost Communication with Cruise Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the millimeter wave radar sensor assembly and hybrid vehicle control ECU is detected for approximately 1 second or more. | CAN communication system | Radar Cruise1 | B |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 and hybrid vehicle control ECU is detected for approximately 1 second or more. | CAN communication system | Radar Cruise1 | B |
| U029387 | Lost Communication with Hybrid/EV Powertrain Control Module Missing Message | When the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 and hybrid vehicle control ECU is detected for approximately 1 second or more. | CAN communication system | Radar Cruise1 | B |
| U117008 | Lost Communication with Brake System Control Module (ch2) Bus Signal / Message Failure | After approximately 2 seconds have elapsed since turning the ignition switch ON and with the dynamic radar cruise control system on, data communication is lost from the skid control ECU (brake booster with master cylinder assembly)*1 or skid control ECU (brake actuator assembly)*2 to the hybrid vehicle control ECU for approximately 3 seconds or more. | CAN communication system | Radar Cruise1 | B |
*1: for TMC Made
*2: for TMMF Made
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| U010487, U012287, U029387 or U117008 is output | A |
| DTCs are not output | B |
| None of the above conditions are met | C |
Post-procedure1
None.
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
C