| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|
| C13B800 | Electric Parking Brake Actuator | ·
Diagnosis Condition: Electric parking brake operating ·
Malfunction Status: Repeated slipping is detected ·
Detection Time: - |
·
Parking brake actuator assembly ·
Rear brake |
DTC stored | Electric Parking Brake | B | An electric parking brake system malfunction is displayed on the multi-information display. |
Although DTC C13B800 may be stored after entering pad replacement mode, this is not a malfunction.
Although DTC C13B800 may be stored after forcibly releasing the parking brake, this is not a malfunction.
To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.
After replacing the parking brake ECU (brake actuator assembly), perform "Calibration".
When replacing the parking brake ECU (brake actuator assembly), operate the electric parking brake switch assembly as the parking brake indicator light blinks when the ignition switch is first turned ON.
Using the GTS, check for DTCs other than DTC C13B800.
| Result | Proceed to |
|---|---|
| Only C13B800 is output | A |
| C13B800 and other DTCs are output | B |
A
B
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for 2WD | A |
| for AWD | B |
A
B
Lift the vehicle and check the status of the rear wheels using the GTS when the electric parking brake is applied and released.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR (for TMC Made 2WD)>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
Lift the vehicle and check the status of the rear wheels using the GTS when the electric parking brake is applied and released.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR (for AWD)>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT