| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|---|
| C13B800 | Electric Parking Brake Actuator | ·
Diagnosis Condition: Electric parking brake operating ·
Malfunction Status: Repeated slipping is detected ·
Detection Time: - |
·
Parking brake actuator assembly ·
Rear brake |
DTC stored | Brake/EPB | B | An electric parking brake system malfunction is displayed on the multi-information display. |
Although DTC C13B800 may be stored after entering pad replacement mode, this is not a malfunction.
Although DTC C13B800 may be stored after forcibly releasing the parking brake, this is not a malfunction.
The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.
Using the GTS, check for DTCs other than DTC C13B800.
| Result | Proceed to |
|---|---|
| Only C13B800 is output | A |
| C13B800 and other DTCs are output | B |
A
B
Lift the vehicle and check the status of the rear wheels using the GTS when the electric parking brake is applied and released.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR (for TMC Made 2WD)>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT