This circuit is used when the voice switch of the steering pad switch assembly is pushed.
Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.
Disconnect the H83 radio and display receiver assembly connector.
Disconnect the H137 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H83,H137)Location & Routingewd_type=routing;type=c,c;code=H83,H137 Click Connector(H83)Instrument Panel>Instrument Panel Wire / Speaker Wire>Radio & Display Receiver Assemblyewd_type=component;type=c;code=H83;pinno=3,8 Click Connector(H137)Instrument Panel>Instrument Panel Wire / Speaker Wire>Stereo Component Amplifier Assemblyewd_type=component;type=c;code=H137;pinno=15,14,18 |
||
| H83-3 (RL+) - H137-15 (II1+) | Always | Below 1 Ω |
| H83-8 (RL-) - H137-14 (II1-) | Always | Below 1 Ω |
| H137-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| H83-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| H83-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG