| *a | Centering Bolt |
| *b | Standard Bolt |
Use the same procedure for the LH side and RH side.
The following procedure is for the RH side.
Centering bolts are used to install the door hinges to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
The specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
67003
1.INSPECT REAR DOOR PANEL SUB-ASSEMBLY
Check that the clearance measurements of areas "A" to "M" are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3.5 to 6.5 mm (0.138 to 0.256 in.) | B | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| C | 3.5 to 6.5 mm (0.138 to 0.256 in.) | D | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| E | 3.8 to 6.2 mm (0.150 to 0.244 in.) | F | -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) |
| G | 3.8 to 6.2 mm (0.150 to 0.244 in.) | H | -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) |
| I | 7.8 to 11.8 mm (0.307 to 0.465 in.) | J | -2.0 to 2.0 mm (-0.078 to 0.078 in.) |
| K | 3.5 to 8.5 mm (0.138 to 0.335 in.) | L | -2.5 to 2.5 mm (-0.098 to 0.098 in.) |
| M | 1.8 to 6.8 mm (0.071 to 0.268 in.) | - | - |
67003
2.ADJUST REAR DOOR PANEL SUB-ASSEMBLY
Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.
Tighten the 4 hinge bolts on the vehicle body after adjustment.
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.